Attic pull down stairs – Access to the attic is made easier by installing an attic set down stairs. The stairs are usually made of wood and folded so that they can be stored in the attic access opening. The stairs are often installed by non-professionals and have security issues. It is very important that the loft pull down the stairs are installed correctly to avoid injury. Defects and problems that are often observed in the attic pull the stairs installation. One of the defects of the installation is that the structural members such as rollers or cut to accommodate the stairs of the floor of the cavity. Attic floor the structural members must not be removed or cut without the appropriate reinforcements installed.
All fasteners must be installed and all of them must be tightened to avoid danger. Missing bolts or nuts must be replaced to avoid serious injury. Attic stairs are often cut too short so that the bottom of a set of stairs hung will not touch the floor. These conditions are not safe and can cause serious injury. The basic steps should land solidly on the floor to avoid excess stress on the fixture at the top of the stairs. If the ladder is too old, the hinge will bend and exert too much pressure on the stair hinge. The attic pull down stairs should be cut so that the hinges are not bent and the bottom of a series of steps is flush with the floor. If the hinges are bent downwards, they may break when you travel through the steps and cause injury.
12 Photos Gallery of: Installing Attic Pull Down Stairs
The attic pull down stairs steps must be secured with the required amount of screws. Often very few fasteners used to secure your attic go down the stairs in an access to the attic. Check with manufacturers and install the required number of screws in the correct location to secure the solid steps in the hatch frame. Another problem that occurs with the spring arm assembly. Often the springs slide the spring guide and this causes the spring arm to bend backwards making it impossible to close the step without using your hands to pull the arm back into position. Make sure the spring is properly seated in the guide spring.